The flame goes around the burner what would do this?
Check out some similar questions!
Furnace troubleshooting [ 3 Answers ]
How do I locate my furnace relay switch?
Furnace troubleshooting [ 2 Answers ]
What's wrong when my furnace starts blowing hot air then stops and shoots out cold air... then when I check the thermostat the temp went down by itself...
Rheem furnace troubleshooting [ 3 Answers ]
My Rheem quit lighting. I cleaned flame sensor nothing. It does work once in awhile. The 2 green leds light no orange. Once in awhile when it lites I get steady orange. When it tries to lite it will go through whole sequence lite for 10 seconds then go out. Then it won't work for several days. I...
Luxaire furnace troubleshooting [ 2 Answers ]
My furnace manual says I can set the fan off delay on the PC board.my model has no such jumper that I can see.does the primary limit switch (open@140/close@100)control the blower? After gas shutoff the blower runs twice as long as I would like, sending cold air into the rooms.
Furnace troubleshooting [ 1 Answers ]
I have an amana furnace about 20 years old. Model #ghi115a35. When I put the thermostate at 70 or 75, does not matter, the inducer motor comes on, the glow light is on, the gas valve will open, but will not ignite the burners. Then the gas will close, I try again, about two times, then the gas...
View more questions Search
Add your answer here.