Where is the filter located for an Armstrong Ultra V Tech 80 furnace? How often should it be changed? This is a forced hot air system. Also has central air. Can they be purchased locally ie: Home Depot or Lowe's? Tha nk you.
Add your answer here.
Check out some similar questions!
Armstrong Ultra SX 80 furnace won't stay on [ 16 Answers ]
We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...
Armstrong ultra sx-80 furnace problems [ 4 Answers ]
I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...
Armstrong Ultra V [ 1 Answers ]
Armstrong Air Ultra V, 4 yrs old: Problem: *Igniter comes on with bright red/blue flame *Burners then come on *Fan blower comes on *Shortly after blower comes on, burners go out, and blower continues to run *Igniter comes back on *Burners then come back on *Then Burners go out again...
Where do I purchase original Armstron Air Ultra V Tech 80 FILTER [ 3 Answers ]
I have just acquired this new job and we have an Armstrong Air Utra V Tech 80 furnace. It came with a blue 16 x 25 filter which hadn't been replaced in 9 months. I went to Ace Hardware and bought a 16 x 25 filter which I found they do not fit. I need to purchase the original filter that...
Adding a Humidifier to a Armstrong Air Ultra V Tech 80 [ 1 Answers ]
I am installing an Aprilaire Humidifier 500a on an Armstrong Air Ultra V Tech 80 furnace. Where do I get the 24 VAC from the heating side of the furnace to feed the humidifier control?
View more questions Search