Check out some similar questions!
Armstrong Ultra SX 80 furnace won't stay on
[ 16 Answers ]
We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...
Armstrong ultra sx-80 furnace problems
[ 4 Answers ]
I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...
What size filter does the armstrong air ultra 80 sx use?
[ 0 Answers ]
What size filter does the armstrong air ultra 80 use?
Armstrong air ultra sx 80 furnace
[ 7 Answers ]
I have an Armstrong Air Ultra sx 80 model# GUJ075D10-2B. The furnace has satisfied the call for heat and everything has shut off and waiting for the next call. The problem is on the start-up. When the igniter starts the flame, it is like there is a small build up of gas in the heat exchanger and...
Adding a Humidifier to a Armstrong Air Ultra V Tech 80
[ 1 Answers ]
I am installing an Aprilaire Humidifier 500a on an Armstrong Air Ultra V Tech 80 furnace. Where do I get the 24 VAC from the heating side of the furnace to feed the humidifier control? View more questions Search
Add your answer here.
|