Check out some similar questions!
Goodman furnace runs but not always with flame first
[ 0 Answers ]
My Goodman furnace sometimes starts up, vent fan, then the gas does not ignite or even appear, then blower runs through its cycle and shuts off, blowing unheated air around. It does this about 30% of the time now. A HVAC pal filed off the igniter rod saying it was corroded. He said there was...
Goodman furnace. Longer intervals between heating cycles
[ 1 Answers ]
I have a Goodman furnace about 9 years old. The house is also 9 years old. It has been working okay for the last 2 years. Last week it started giving longer intervals between heating cycles i.e. it comes on for 20 minutes after every one hour. The service tech replaced the flame sensor and declared...
Goodman 90 plus furnace flame sensor
[ 6 Answers ]
Goodman furnace is showing single blink every 2 seconds. I see that a possible problem is the FLAME SENSOR. My main question: Is the flame sensor the SAME part as the ceramic ignitor ? If different, where is it in relation to the ignitor ?
Furnace cycles and flame comes on and say on for 10sec
[ 3 Answers ]
Furnace comes on cycles when it get to the flame lighting it lights and goes off after 10 secs... its not the flame sensor I changed it
Goodman furnace cycles but does not reach set temp
[ 2 Answers ]
I have a Goodman 70,000 BTU, up flow gas furnace (GMV950704CXA) with a Honeywell (RTH 7500D) thermostat installed, November 2006. The unit worked fine until outside temperature went into the 20s. Unit fires and goes through normal sequence and runs for approximately 7 minutes, then cycles down... View more questions Search
Add your answer here.
|