Ask Experts Questions for FREE Help !
Ask
    PADRE's Avatar
    PADRE Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 13, 2007, 05:39 PM
    Stair rail end piece
    What is the best way to join the stair rail end piece to the stair rail. I have both the stair rail and the end piece cut at 45 degrees. The end piece is 3 1/4 inches long. Thanks for all suggestions.
    sledgehammer's Avatar
    sledgehammer Posts: 12, Reputation: 4
    New Member
    		  
    #2

    Jan 26, 2007, 08:49 PM
    You have the right idea. 45 degree joint, drill a dowelplug hole(make sure you have the dowelplug size 1st e.g. 3/8",1/2"), and predrill a pilot hole underneath rail prior to assembly.. Use plenty of glue and woodscrew it together. Off set the pieces to allow the screw to pull it into position. You see what I mean when you try it.
    It's OK , you can reposition it. When it's together , let the glue set, use filler and sand in the profile of the rail to match. Install a dowel plug underneath to hide the screwhead.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How high should a chair rail be? [ 3 Answers ]

I am thinking of adding a chair rail in my dining room, but I don't know how high it should be. Is there a standard height? Also, how do you deal with doors and larger openings without doors (like between the kitchen and dining room)? How about windows? We have standard size double hungs that...

Chair Rail up Stairs [ 2 Answers ]

I would like to put chair rail up a stairway, but the problem is that it would interfere with The existing handrail. Which way is better - to put it above the handrail, below it, or even with it? I'm using half-round, so even with the handrail would make it tough to use the Hand rail. Also,...

Stair building [ 1 Answers ]

I'm in the process of finishing the basement and only have the stairs left as far as framing. What do you think, rework the stringers that are here or tear them down and rebuild them? They will remain open and have a railing running along the landing and down the stairs. My main concern is how...

Chair rail trim [ 1 Answers ]

How do I end the trim on an open corner? Straight cut or miter cut?

Front-end vs. Back-end Tech Writing [ 4 Answers ]

What's the difference? Can someone give me an example of both? I'm SO confused! :confused: Thanks in advance. -HBG

View more questions Search