| 
 
 Check out some similar questions!
White Rodgers control board 50a50-471
 [ 0 Answers ]
 Board died, replaced it with 50a55-843. Put in ro1/ro2 jumper. When I turned it on both the inductor motor and the blower came on. The furance fired up but after 1 minute the blower turned off. It reached high temp limit and shut down. Anybody have any ideas? 
White Rodgers model 50a50-288 3A fuse location?
 [ 1 Answers ]
 White Rodgers model 50A50-288 low voltage fuse location 
Help with a White-Rodgers Model 50A50-471 Furnace Control Board
 [ 0 Answers ]
 My Problem: My furnace is pumping out tepid cool air Last night my house started blowing tepid cold air. I turned the heat down until it "clicked" off from the thermostat in the main room. I went down into my basement and opened up my furnace. I had not changed the filter in the last 3 years... 
Burned White-Rodgers 50A50-471 Furnace Control Board
 [ 29 Answers ]
 I woke up this morning full of Christmas cheer and then I noticed it was too cold (I have compromised with my wife to turn the heat down to 65 degrees at night, but not 60! Brrr!) I noticed the circuit breaker was tripped so I reset that. The circulation blower comes on but no ignition or... View more questions Search 
 Add your answer here.
 |