Ask Experts Questions for FREE Help !
Ask
    skyawkingron's Avatar
    skyawkingron Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 16, 2012, 05:22 PM
    What could be the problem with a stationary CDI?All else works fine.
    #2nav/com inop/xmt OK,no rec.
    Problem repaired with the vor calibrated. CDI does not swing/deviate.
    All other fumctions( to/from/off/id) works fine.
    Do I need to pull the vor head?
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Aug 16, 2012, 06:16 PM
    This is truly like reading Chinese. (which I can't!)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dryer Help: Dryer works fine and turns on fine but will stop heating after 1-2 minute [ 2 Answers ]

Hello. I have a Frigidaire Electric Dryer Model GLEQ215ESO. My dryer had a bad bearing and heating coil so I replace it about 6 months ago. It was working perfect up until a week ago when my cloth wasn't drying. I took a look at it and it seems to work fine for the first 2 minutes of use and then...

So I'm having the same problem. The 3 lights won't work but the fan works fine. [ 2 Answers ]

I pulled the light assy down and did see the blue and black coming from the chain switch. I did a ohms test and the switch is fine. Any other suggestions?

A/c Unit fan inside won't run,But Outside Unit works fine. What's the problem? [ 2 Answers ]

The Outside Unit is working fine. The inside Unit fan won't come on and makes a humming noise.

Air works fine but heat won't come on at all [ 1 Answers ]

My air condiction works fine bu when I put it on heat it won't come on at all no fan no noise or anything only thig I hear is a clicking on the circuit board that's it I have a lennox furnace Thanks in advance

Reset works fine, but... [ 5 Answers ]

This Kenmore dishwasher, model 1376, works great and very quiet also. ... and then it stopped working. I suspect I might have placed something in there that blocked the spray arms. What worries me is that there wasn't/isn't any blinking light to indicate "fault" has been detected. Hope I didn't...

View more questions Search