Ask Experts Questions for FREE Help !
Ask
    Tom Jaeger's Avatar
    Tom Jaeger Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 8, 2012, 09:19 PM
    Single switch install keeps cycling on and off
    I purchased and installed your PR 180 occupancy sensor to automatically turn the light in the hall. The light comes on and shuts off in 30 secs. The problem is that it does not stay off. In a second or two it comes back on and continues to recycle and recycle. I have turned the sensitivity down to it's lowest setting and it continues to do the same thing.

    I have hooked the black, white and green wires up (single pole). Can you help me?

    Tom ([email protected])
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Sep 9, 2012, 05:23 AM
    You should have it wired correctly, pretty simple.

    You should call their help desk for advice;

    Tech Line (8:30AM-7:30PM E.S.T. Monday-Friday): 1-800-824-3005
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Light switch red black white wires single switch [ 1 Answers ]

Hello everyone, been reading many questions and answers about light switches but it's not exactly as the problem I'm facing... So I'll try and be specific and clear... So this is a new house, we moved in a week ago, so I wanted to change the regular switch in the bathroom for one with a moving...

How to wire a single pole switch to a single grounded receptacle? [ 3 Answers ]

I have 2 15amp single pole light switches that have just 2 brass screws and a green grounding screw on them and I have 4 15amp 125v grounded single receptacles that I want to wire up for my light switches to operate 4 sets of fluorescent lamps which already have plugs on them and one that has a...

Install a single pole switch & grounding receptacle combination [ 2 Answers ]

I want to install a single pole switch & grounding receptacle combination and would like to know how the wiring go's on the switch, maybe a schematic. I want the plug to be hot all the time. Thank you! Jim.

Well pressure switch not cycling pump [ 1 Answers ]

A couple of months ago I replaced the pressure switch on my pump. It was working fine, until last night. The system is using a 1/2hp jet pump with a diaphragm tank for storage. As I stated it has been working fine until last night. When the pressure drops to what should be the cut in point, the...

Furnace fan cycling switch [ 1 Answers ]

What are the settings about on my gas furnace fan cycling switch.

View more questions Search