 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Cost to Change 100 amp fuse to 100 amp breaker or bigger.
What is the approximate cost and process to change a 100 amp fuse system to a 100 or more amp breaker system? I know that this obviously must be done by a professional. Does this involve changing meters along with the panel box? The current wiring is sufficient. Becket MA
|
||||
|
||||
|
If the existing wire is adequate, why change? Other than the obvious ability to flip the breaker, if, as you say, the wiring is adequate, you shouldn't be changing fuses. With a new install, you may be required to also change the meter box that contains an outside disconnect. Depending on your location and pay scales, prices vary considerably so get 3 bids from qualified Licensed electrical contractors. Meters are supplied by the local utility. If you want to go up in Amperage, you will possibly need to have a new service from the street and a new install from the meter to the panel. That could substantially increase costs as SER cable is expensive.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
An Electrician friend said I could use #4 copper for the (2)120 volt legs and a conventional Suspension wire as the nuetral. The overhead span is about 35 feet and the overall run From panel to panel is about 70 feet.The supply outlet said to use #2 copper. Also, what type wire for sunlight...
I am buying a house with 100amp service and the home inspecter said I would need at least 150 amp panel to service the hot tub that comes with the home. However, the hot tub is hooked up to the 100amp service panel and the hot tub works fine. Am I really running into any issues here if I do...
I am moving my sub panel and upgrading to a 200 amp service, but in phases. The first phase is to move the panel due to some remodeling. I want to put a 200 amp panel in the laundry room with a 200 amp breaker. I have 100 amp feeder wire going to it (AL 2/2/2). Outside I have the meter can and...
Hello all, This is my first post so I hope I do it right. This is what I got. The drop from the pole comes down to one 200 amp meter. The 200 amp meter feeds only one panel with a 100 amp input breaker and has many breakers that power the house (stove, water heater, dryer, outlets). Then it...
Hi, I know nothing about electricity but am buying a 4-apartment building that was built in 1930. Each apartment is about 1000 square feet, 2 bedroom and 1 bath. Space heaters and wall-unit air conditioners only... Each apartment has a fuse box and 100 amp service. I want to upgrade to...
View more questions Search
|
