Ask Experts Questions for FREE Help !
Ask
    Dallas09's Avatar
    Dallas09 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 18, 2013, 10:55 AM
    Cut ground wire on pool table light
    Accidentally cut ground wire on pool table light. Can I safely splice together with electrical tape or electrical wire nut? Will,probably purchase new light, but want to be safe in the mean time.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Feb 18, 2013, 07:25 PM
    Ground wire or was it possibly the neutral? If it was a bare or green groundn wire you can splice it together twisting the two end and then a wire nut, no taping
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

For an Above Ground Pool, can I run UF-b 12-2 wire in Schedule 40 Conduit? [ 2 Answers ]

Im running underground wiring from my house about 8 feet to an 18 foot round 48 inches deep to pool pump using GFCI on outside of house and Twist lock outlet 6 feet from pool. Can I use UF wire run through schedule 40 conduit or do I need to use THWN single conductors through conduit?

Old pool light wire will not pull [ 1 Answers ]

Small 1/2 copper tubing in very old pool wire will not pull , is my only option replacing pool deck and running PVC, wow that would be expensive just for a pool light

How do I wire a switch with pilot light with 1 black, 1 white, and 1 ground wire? [ 1 Answers ]

I replaced an outdoor outlet controlled by an interior switch with a Cooper gfci outlet and it tested fine. Then I replaced the existing switch with a Cooper switch with pilot light. The switch has one line coming into it with one white(hot), one black(neutral), and one ground. When I connect...

Above ground pool: Wire size and burial method? [ 3 Answers ]

Hi, I'm planning to run a pair of circuits to the backyard for an above ground pool. The pool pump + salt cell requires a 20 amp @ 120 volts circuit, and I calculated that #8 AWG conductors are required to keep the voltage drop below 3%; the run is about 190 feet. The second circuit will only be...

Leaking above ground pool light [ 3 Answers ]

:) I have a 15x30 above ground pool. With the terrible winter we have just experienced, the pool light is now leaking from what I can see out the exterior of the large plastic nut that retains the light to the wall. Dripping at a rate of about 40 per minute. Have tried to tighten with my hands but...

View more questions Search