 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Timer wiring and installation
Trying to connect a SunSmart digital timer to replace a single switch for exterior light. Only two wires are connected to the old switch - line in and load - there is no neutral and no ground.
I have connected the line in to black on the timer and load to blue. Where should I connect the white - neutral - wire to? The timer is connected but not working. |
||||
Check out some similar questions!
Whould somebody tell me how to install the T194R timer to a water bomb 1.5 hP 15amp and another pump 1hp both used for water fall. Hanks, Vic
I just purchased GE basic wall timer model 15070 and am having trouble getting the clock to work. I have a single wall switch with 2 black wires and a copper ground. My timer has a black, white and red wires. How do I hook them up? I can get the light to work with the manual switch but not with...
I need to wire a 220 volt intermatic timer with 3 15 amp loads but have lost the instructions .Can someone give me a diagram and instruction?
My clock on an Intermatic T101P3 timer went belly up and I got a new 110V model. However the problem with the new unit is that the output gear location is slightly different relative to the two mounting holes. This means that I can bolt the clock onto the body, the gear doesn't mesh and driver the...
Help! I just purchased a new Pentair Whisper Flow pump and an Intermatic multipurpose control unit. I am a little confused as to how to correctly wire the pump to the control. In the wiring diagram for the control unit, it indicates a common line going directly to the pump motor. Is the common line...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
