Ask Experts Questions for FREE Help !
Ask
    sferguson326's Avatar
    sferguson326 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 6, 2011, 10:30 AM
    3 prong plug on my generator to 4 prong receptacle on my transfer switch?
    I have two 120v duplex receptacles on my GEN4065 4000watt portable generator and I have ourchased a Emergen 6-5100A 5000 watt manual transfer switch which has a 4 prong twist lock plug. How can I wire the generator to the transfer switch to the generator?
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Sep 6, 2011, 03:45 PM
    The generator that you have is not designed for connection to a transfer switch. I went through the manual and saw the two 20 Amp 120 Volt receptacles as well as the DC receptacle.

    This is a small portable generator that is used for a camp site or tailgating.

    The only available lines you could use in a residence are from the two 20 amp circuits. And you would need the correct type cord (one is provided in the packing) to connect these receptacles and then feed the two possible circuits in the home.

    You cannot use this unit to operate off a transfer switch to a panelboard.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Connect 240V 3 prong motor to generator W/ 240 4 prong outlet? [ 6 Answers ]

As summarized, I'd like to run a 240 volt motor with 3 prong twistlock plug off my Generator that has a 240V 4 prong twistlock outlet, Have purchased a 4 prong dryer plug & cord. Not sure what function the extra lead performs, any help is greatly appreciated, Thanks...

My generator has a 6-R receptacle, but my transfer switch is an L14-30 plug. [ 1 Answers ]

My generator has a 6-R receptacle, but my transfer switch is an L14-30 plug. How do I configure the wire to connect the two?

4 prong plug on new dryer vs. Three prong wall receptacle - best fix? [ 2 Answers ]

I just purchased a new dryer that has a 4 prong/blade plug. My home is older and the installed receptacle is only 3 prong. I thought it best to try to replace the old 3-slot wall receptacle with a new 4-slot. The three wires inside the old receptacle are black, white and bare copper. I see...

Replacing 2-prong receptacle with 3-Prong -NO GROUND WIRE [ 6 Answers ]

Hi there! I was wondering if someone can tell me how exactly I go about doing this safely. I have an existing 2 prong ungrounded plug... theres no ground to this receptacle... old metal box does not seem to be grounded either. I would like to replace this receptacle with a 3 prong GFCI...

View more questions Search