Ask Experts Questions for FREE Help !
Ask
    gbrickle's Avatar
    gbrickle Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 7, 2010, 07:13 AM
    Can I replace a 20amp breaker with a 25amp breaker safely?
    Can I safely replace a 20amp breaker with a 25amp breaker... application is a pool pump. The motor is drawing too much on the 20A line...
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Aug 7, 2010, 07:34 AM

    Nope. Not normally.

    What is the motor rated for (amperage)?
    120v or 240v?
    What size wire was run?
    How far is it from the panel?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I just replace my breaker box but it didn't have a main breaker is that safe ? [ 5 Answers ]

On the box it says it is a 100 amp breaker box and I have 1 50 amp breaker .2 30 amps breaker and 3 20 amps breakers if I add all the breaker it is 170 amps and my breaker box is for 100 amps is that how it works? Do I need a bigger breaker box? Is it unsafe...

20amp DP Breaker GFCI [ 1 Answers ]

If I install a 20amp DP GFCI breaker will it work correctly if the hot tub works on 240 only. The tub has no neutral.

20amp Dp Breaker [ 1 Answers ]

I have a indoor whirl pool need, need 240v 20amp DP breaker to operate. If this tub is hard wired does it need to be on a GFCI?

How do I safely replace circuit breaker? [ 3 Answers ]

In my garage I have two separate overhead light bulb sockets, each is connected to a separate wall switch. One works, the other does not. Using a tester, there is no power at the socket that is not working. I have replaced the wall switch and the fixture, it still does not work. The last thing...

15AMP Breaker used instead of 20AMP -ok? [ 4 Answers ]

We just had an electric gate installed that extends across our driveway. I noticed that the installer used a 15 amp breaker switch to connect to for power (the gate is the only device on this breaker). In looking at the manual last night the installation instructions call for a 20 AMP breaker (the...

View more questions Search