Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Existing no ground wiring and adding new.
 [ 1 Answers ]
 I currently have a two gang switch box where there is an original non-grounded circit running to one of the switches. I am adding a new circit and switch to this box which of course has a ground, do I pigtail all the ground wires together and run one of the tails to the grounded switch (circuit)... 
Open ground when neutral not touching ground
 [ 3 Answers ]
 Hi, I was moving around a room and noticed my wife wanted her desk elsewhere. I decided to, since she would have her computer on it, check the outlet she would be moving to. It seemed old so I changed it. I noticed before I changed it that with my GFCI tester, all sockets on this circuit were... 
A hole in the ground
 [ 1 Answers ]
 I have a drain in the floor of my basement that has given me some problems. Once, I had sewerage back up through that drain and my basement was filled with human waste. A plumber came in and snaked our main pipe at an entry at the bottom of the basement stairs, which fixed the problem. Four... 
Wiring Ceiling Fan with Two Ground Wires
 [ 6 Answers ]
 Trying to install a ceiling fan... From ceiling: white, black, green and copper wire From fan: white, black, blue and green Connected white.white, black & blue to black... QUESTION: Do I connect green from fan to green in junction box, or to green and copper in junction box? If... 
Wiring the ground
 [ 3 Answers ]
 
I replaced my Lennox blower control board with a Lennox control board kit 31M73 on my heating and AC. Question: I am left with the green ground wire (screwed into the back of the panal) which came off the old board which read 'heater/fan control common'. There isn't anywhere left to plug... View more questions Search 
  |