Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Joining 2 different gauge wires
[ 3 Answers ]
I knocked down part of a wall and as a result need to move some outlet wires. I found a good and legal place to put a junction box but the existing wires are stamped 16amp (35yr old house),(I assume that means about a 14ga) and I have 20ga (romex 12/2)---the circuit has a 20amp breaker. Can I join...
Ground Wires
[ 28 Answers ]
OK... Im wiring up a detached building and I have ran into a small problem. Might be a dumb question but here goes. Im feeding from the box under my meter out to the shed. Im running 6/3 w gnd. I got the shed sub panel under control. But in the box under my meter for the fround wire, there is not...
Ground and neutral Wires
[ 9 Answers ]
Is it proper to connect the ground and neutral to the neutral buss? I am installing a sub panel from a 200amp svc to a 125 service using 6g. My sub box does not have a separate ground buss rather only 2 neutral buses with a crossbar. I was informed that I can put the neutral and ground on that...
Connecting 14 gauge wire and 12 gauge wires in the same blue box.
[ 2 Answers ]
I am wiring my basement. All the outlets are running off 2 independent 20 amp circuit breakers connected to each other by 12/2 wire. I wanted to run some stubs off my 12/2 outlets. All each stub would do is run to a small light (max 180 watts) and of course a light switch. Since I ran out...
Wiring different gauge wires (18 awg to 14 awg)
[ 5 Answers ]
I recently bought a house that has a nice wall lamp in the living room that I would like to keep as I renovate it. The lamp came wired with 18 awg wire (1 neutral, 1 hot, and 1 ground). The previous owner wired the lamp to a standard wire with a plug to make it a plug-in fixture. I don't know if... View more questions Search
|