Ask Experts Questions for FREE Help !
Ask
    MARI3034's Avatar
    MARI3034 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 21, 2008, 05:43 PM
    Need to remove casing to replace halogen bulb
    Hello. I have a HARBOR BREEZE 69" inch AIRSPAN ceiling fan and when it was installed, apparently the bulb casing in the center was tightened so that I am unable to remove it to replace the bulb. But atleast the fan part works. Also I have a HUNTER 52" BERKELEY ceiling fan as well and apparently, a wire must have disconnected somewhere and I don't know where to start to repair because the fan and the light don't even turn on. HELP! Any advice is appreciated. Thanks.
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
    		  
    #2

    Jan 21, 2008, 07:23 PM
    To remove the light glass, you have to apply pressure and rotate it. It may be difficult, but be careful not to break it.

    The Hunter fan, does it have a remote?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing Halogen bulb in Hampton Bay product [ 5 Answers ]

I have a ceiling mounted Hampton Bay product with one T3 halogen bulb and four spots. I cannot remove the burned out T3 to replace it. Any suggestions?

Remove and replace starter [ 2 Answers ]

I need help on how to remove the starter on a 1995 Crown Victoria?

View more questions Search