Needing to run power to splitwire receptacle to a two gang box using one switch to control receptacle and pigtailing from switch to receptacle to another switch going to two lights.. looking to see if someone can help me diagram that

I am trying to change my light switch, but the problem I have is the old switch has a red, black and white wire connected with 3 different screw places for each wire. The new switch only has 2 connection screws, so I am wondering how to wire this up? FYI The house was built in 1954. And there is no...

Wall switch box has two black wires and two white wires(spliced. New switch has black wire, red wire(light),yellow wire(fan), and green wire(ground). I think I need an independent wire for the fan and light. How?

I am trying to swap out a dual switch for a switch that has a dimmer for the ceiling fan light and a three position switch to control the fan. The original wiring had white to white on switch, black to black on switch, and one black from light connected to the top switch pole and the other black...