Ask Experts Questions for FREE Help !
Ask
    mistydawn04's Avatar
    mistydawn04 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 10, 2013, 01:46 PM
    How would I go from breaker box to pressure switch to the well it is running on 110 .
    How do I go from the breaker box to the pressure switch then to the well. The well is on 220 and the pressure switch is on 110. The pressure tank is in the form of a big concrete holding tank. The well is inside a bldg next to it. I don't know how to get power to the switch because it has an existing 8-3 feeding the pressure switch only
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #2

    Feb 10, 2013, 04:37 PM
    What do you mean the pressure switch "is on 110"?


    I don't know how to get power to the switch because it has an existing 8-3 feeding the pressure switch only
    If it has an existing 8/3 then why do you have to feed it?

    I am very confused.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
     
    #3

    Feb 10, 2013, 06:17 PM
    I'm lost too. Is the pump above ground or submersible? If the pump is 240v, the pressure switch should be too.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Open pressure switch with inducer motor running [ 0 Answers ]

I have 3 flashes when the furnace shuts off inducer is still running.When it shuts down wait a few min and the furn. Comes back on again.Is this normal operation?I do have a drain opposite side of the inducer.Is that on the wrong side of the furnace.Concord 95.

We are adding a breaker box in a barn the wire we ran from the pole breaker box [ 1 Answers ]

The wire is 2 ft short and the box will be too low... can I splice another piece to it? And how do I do it

Breaker Box switch limits [ 5 Answers ]

Hello, I'm thinking of adding a receiver and TV speaker's to an existing line, but am having trouble understanding my breaker box switches. I have square D 200 amp breaker box. On the first picture I've attached, left hand side at the top, you can see two slots with a single switch in each....

Pressure switch for well keeps triping breaker. [ 2 Answers ]

I have a 30/50 pressure switch that is a part of my well system. When this switch is called on by normal system demands, it RAPIDLY FLICKERS ON & OFF. Sometimes for a short period 2-3 seconds, others for 5-7 seconds. When it does this it trips the breaker and then obvously - no water pressure. ...

Square d pressure switch trips circuit breaker [ 1 Answers ]

My square d water pressure switch 30-50 cut in and out switch needs help.when it drops to 30 cut in pressure it trips the circuit breaker has to be manually starter with lever on the side of the square d switch,it might work properly 3 or 4 times then it trips the circuit breaker please help if you...


View more questions Search