Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Does one gfci cause another to trip if there are 2 on same circuit?
[ 5 Answers ]
I am installing a heating system underneath ceramic tile. The system will only pull about 5 amps and I want to get my juice from an existing source. The wirlpool is on a circuit of it's own 20/amp breaker and it is only pulling about 7-8 amps. So far so good, However the breaker is a gfci breaker...
GFCI circuit breaker
[ 3 Answers ]
I was hosing down an outside wall and must have sprayed too close to my electrical outlet (This outlet had a pump plugged into it) as it tripped the GFCI in my bathroom. I reset the GFCI and went back outside and the pump was still not working; I went and reset the GFCI once again and now the...
15A receptacles on 12/2 GFCI Circuit
[ 5 Answers ]
I was just looking at some of the wiring that was done in my house when it was built in 2003. I have one GFCI Circuit that has 5 receptacles on it. On this, it is wired all with 12/2 to the garage first, where the receptacle is the GFI, then it runs 3 outdoor receptacles, and 1 in the basement. ...
GFCI Circuit Breaker.
[ 2 Answers ]
I recently ran a branch circuit to the exterior of the house to add a receptacle on the patio. The existing 15 amp breaker protected a circuit that had only three plug outlets and one switched ceiling light. The circuit is very lightly used. So I want to add GFIC protection in the form of a breaker...
Wiring a switch and GFCI circuit
[ 3 Answers ]
I am in the process of wiring my bathroom. The lighting and fan circuit has one fan, one overhead light and one vanity light. I was wanting to use a NuTone single space / 3 switch unit for all three. Wiring that is all very straight forward but the fan requires a GFCI circuit to make it OK for over... View more questions Search
|