Ask Experts Questions for FREE Help !
Ask
    rhutchens's Avatar
    rhutchens Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 2, 2011, 11:35 AM
    How to install a siemans 1060su panel?
    How do you install a siemans E0204MNL1060SU panel?
    The main lug 60amp panel has only one buss bar. Lowe's says that is all you need these days. So the hot, the neutral and ground all attach to the single bus bar? I tried that per their instructions and it will not work./ I guess I do not get it! Please help. Thanks
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Dec 2, 2011, 12:56 PM
    Do not take advice from a store clerk unless they have a license for the trade they are giving advice for.

    We need to know more about what this panel is for, how it is connected, etc.

    Some photos would be very helpful.

    After the Main Disconnect, the neutral and equipment ground are to be insulated and isolated.

    I suspect this is a "subpanel", if so a separate equipment ground bar is need for the panel. They sell them there at the store.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to install a sub panel [ 1 Answers ]

Iam installing a 100 amp sub panel in my basement. The new panel is right beside the 200 amp panel. I am installing 2 20 am circuits and 5 15 amp circuits. What size wire do i need for this installation and how do i connect it to the 200 amp panel?

Should I install a sub panel [ 1 Answers ]

There is an addition on my house that is a bedroom with a garage underneath. The wireing is jacked up and I was thinking of installing a sub-panel in garage to service the bedroom and the garage. Is this advisable? If so, how many circuits should I put in the panel? There is one slot open on the...

Sub panel install [ 2 Answers ]

I want to install a sub panel in my garage mainly for Christmas decorations. I have an unused 220 out let in the garage, that I was thinking I could use to feed the sub panel. However it was installed by the previous owner, and I am not sure what circuit it goes to in the main panel. My assumption...

Sub-Panel install [ 1 Answers ]

I'm in the process of some mild renovation and I'm going to need to install a few new circuits at the opposite end of the house than the main panel is. The path the cable has to take to get there is rather complicated, I was thinking it might be easier to run one larger cable and set up a sub-panel...

View more questions Search