Hello, I just purchased a new pull chain switch for my ceiling fan light. The lead wires coming down are white and blue. The wires on the new switch are black, blue and red. Normally these are simple installs but I need help on how to wire these due to the different colors. Thanks!

Our ceiling fan switch clicks but the fan does not go on. When I opened the housing, I saw that there was 6 wires, 2 of which were white. One of the white wire was not connected, it could have caused the fan to stop working (?). I do not know where this white wire should be connected to as all...

My ceiling fan pull chain broke off inside the switch. It's a Well Tec switch, model e116997. I have my fan motor housing open and I have identified the Well Tec switch... but I can't figure out how to get the remaining brass balls (I think there are 2-3) out, and get the remaining pull chain...

My chain broke off in the switch, it has an L 1 2 3 on the switch with 3 wires, #1 is a blue wire, #2 is a black wire and #3 is a red wire. I don't know what the numbers mean, unless it's a 3-way switch for 3-way bulbs, I don't care about the 3-way stuff, I just want off & on. Our local Wal Mart...

At one time a manufacturer made a helper lever to turn on a light on this kind of light but cannot seem to find it. It fitted right on the switch with an extension so it could be pulled on and would retract into the swith with out hanging up. Anyone lknow of this ltype of helper?