I would like to install a switch for a pull light fixture. The only power is from the light fixture, but I want to put a light switch on the wall as I enter the room, Can you help ?

I want to know how to add a new light to an existing light switch? There doesn't look like there is enough room in the box to add any new wires, and I don't want to over load it. How many lights can you run off one switch?

Hi: I would like to install a pull switch into a fluorescent light (one ballast) that is controlled by a wall switch. The flouescent light is at the end of the another light that is controlled by the same wall switch. Can I switch this fluorescent light from the pull switch? I understand...

I just installed a chandelier light fixture to a pre-existing junction box in my condo. When I flip the electricity back on for the room however, the fixture lights up in spite of the light switch being in the OFF position. When I flip the light switch to ON, the breaker trips. Is the problem...

OK, the walls were open when I did this so hopefully I got the right wire types in before I closed her up! I have a dining room with 4 entry points and I've put a switch box at each location. The power is fed to this lighting circuit through the room lights junc. Box. I ran a 2 plus ground...