Ask Experts Questions for FREE Help !
Ask
    helpinghand's Avatar
    helpinghand Posts: 33, Reputation: 1
    Junior Member
     
    #1

    Jul 5, 2005, 01:30 PM
    Hot/Ground reverse on GFI receptacle
    My screened porch has a ceiling fan w/light and a 2nd light fixture, both running off an outside GFI receptacle. In short, I ran wire from the GFI receptacle to a double switch box; one switch is wired to the fan fixture, the other switch is wired to the light fixture. All has been working fine for well over a yr (passed electrical inspection, etc). Last week I noticed neither fixture was working (may be coincidence, but it was after a lightning storm). When both switches are off, and I plug the outlet tester into the GFI receptacle it shows its fine. However, when I flip either switch on, it shows a Hot/Ground reverse. Again, this was not happening before. When I discovered the problem the GFI had not been tripped. I checked the wiring in the GFI, the switch box and both fixtures and everything is still wired OK. Any ideas? Could the GFI be bad? Thanks!
    Flickit's Avatar
    Flickit Posts: 278, Reputation: 2
    Full Member
     
    #2

    Jul 5, 2005, 03:35 PM
    GFI's require a somewhat...
    Quote Originally Posted by helpinghand
    My screened porch has a ceiling fan w/light and a 2nd light fixture, both running off an outside GFI receptacle. In short, I ran wire from the GFI receptacle to a double switch box; one switch is wired to the fan fixture, the other switch is wired to the light fixture. All has been working fine for well over a yr (passed electrical inspection, etc). Last wk I noticed neither fixture was working (may be coincidence, but it was after a lightning storm). When both switches are off, and I plug the outlet tester into the GFI receptacle it shows its fine. However, when I flip either switch on, it shows a Hot/Ground reverse. Again, this was not happening before. When I discovered the problem the GFI had not been tripped. I checked the wiring in the GFI, the switch box and both fixtures and everything is still wired ok. Any ideas? Could the GFI be bad? Thanks!
    ... specialized tester and may give erroneous readings when using the ordinary colored light testers. If the switches are not working and you had a lightning storm it may not be coincidence... the GFI may have failed. Try resetting the GFI after first depressing the test button on the front that causes it to trip. Once spent a lot of time tracing and cutting wiring trying to find the 'issue' with a GFI only to find it was the GFI itself. When the GFI is caused to trip (button on front) make sure the function works by testing the receptacle with some device to ensure it is tripping the outlet.
    helpinghand's Avatar
    helpinghand Posts: 33, Reputation: 1
    Junior Member
     
    #3

    Jul 6, 2005, 01:47 PM
    Thanks for the info. I am using a GFI outlet tester so I'm OK there. I failed to be specific enough in my original question. The outside receptacle that I am running the two fixtures from, is a regular receptacle but its downwind of a GFI receptacle so its protected. However, I am able to plug in my GFI outlet tester and hit the trip button and it successfully trips the GFI outlet that it runs off. Any other ideas?
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
     
    #4

    Jul 6, 2005, 03:17 PM
    I have never used one of those testers. Shut the power off, and remove both outlets and look at the terminals and wires. Black wire on the brass screws, and white on nickel plated ones. I think I have seen outlets where they even say black and white on them. From there, pull the cover of the breaker box and make sure the black wire goes to the breaker. You could check any other boxes the wires go through.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Mix match plug and receptacle [ 5 Answers ]

Can I wire a 20 amp, 3 pole, 4 wire grounding locking plug to a 50 amp 2 pole 3 wire receptacle? I would like to use a portable generator in a remote area.

Hot Ground/ Reverse [ 5 Answers ]

I have been struggling with an electrical problem for a while now: I spliced into an electrical line in the basement to create an outlet. I wired everything perfect using experience and a home depot manual. I kept getting a hot/ground reverse after purchasing several testers. Then it...

Receptacle testers [ 4 Answers ]

When using a standard receptacle tester on a GFI circuit, I get a Hot/Ground Reverse reading. When I test the same GFI circuit with a GFI Receptacle Tester, I get an Open Neutral reading. The problem was a loose neutral wire . Are these normal readings to expect from the two testers? ...

Installing a gfci receptacle [ 3 Answers ]

I am trying to install a gfci receptacle in my offfice( replacing the existing regular receptacle) I have two black wires that were wrapped together , two gray wrapped together, one single blue and one green. I followed the directions and think I got all the wires to the right place. The test light...

Receptacle wiring [ 3 Answers ]

I want to add a receptacle to a box I have in my pantry that has an existing light switch. I have a three wire load coming in to the box from the circuit breaker. The red is wired to the switch and the blacks and whites are connected with wire nuts. The three wires feed other boxes in my kitchen....


View more questions Search