 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Harbour Breeze fan remote control problem
I was able to prove that my remote control problem is inside the fan, not the remote itself. I reset the dip switches and tried in on an identical fan and the remote works.
I assume the problem is the transmitter inside the fan. Is this a customer replaceable part? If yes, where can I buy it? Can someone describe what this part might look like on a harbour breeze fan? Lastly, is there a Internet site that might have a sketch of what the inside of the fan looks like and what is what? Amateur in Florida |
||||
|
||||
|
It is a replaceable part, easier if it's located inside the ceiling canopy. Does the fan have pullchains or any additional switches (that might indicate the remote kit was added).
Otherwise, contact Harbor Breeze (Litex) for replacement parts. Ceiling fan remote controls - help and FAQ- Ceiling Fans N More |
||||
|
||||
|
There is no pull chain. The fan came from the factory with a remote capability. I assume the receiver module was built-in at the factory. Do you have any idea what a receiver module might look like?
Also, I saw a web site that mentioned the receiver module might be inside the canopy. It the canopy the part of fan that is ABOVE the fan housing and snug up against the ceiling? |
||||
|
||||
|
Yes, but if the remtoe was not an aftermarket kit, it is LESS likely the receiver will be in the canopy, and more likely it will be in the motor housing or switch housing.
It will basically look like a circuit board with a lot of wires going to it. It might be in a case. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Hampton Bay Video & Fan Remote Control (Model #UR8050T). It has been working fine for about 2 years until it recently began malfunctioning. It still operates the television, but the use of the fan/light features has stopped working. It will not turn the fan on or off, and the light is...
For reasons of convenience I swapped the wireless remotes between a Hampton Bay and a Harbour Breeze ceiling fan. The Hampton was an in-the-wall remote with a REV button, and the Harbour was a hand held remote w/o a REV button. Both control units, which get installed in the fan base, appear...
I have three ceiling fans that I installed a couple of years ago with the remote control. I had them all set to the same freq. so one remote contolled them all and I have had not problems until now. After leaving for a week on vacation we got back and none of the three fans will respond to the...
We have 2 harbor breeze fans in our living room. We currently use one remote to control both fans. It was set up that way several years ago by our contractor. One of the lights went out so my husband changed the bulb. Now the remote does not work on that fan. We pulled out the other remote and it...
I pulled the fan from another room where it was working fine to put it in another bedroom. When I hook up the wiring according to the receiver I get nothing from the fan. When I bypasseb the remote receiver I got only the fan spinning and the lights wouldn't turn on. I didn't note the wiring when I...
View more questions Search
|
