Ask Experts Questions for FREE Help !
Ask
    gmlash3's Avatar
    gmlash3 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 15, 2015, 01:42 PM
    The fan light sparked when the wall switch was turned off
    The fan stopped working when the switch on the wall was pushed to shut off the light.
    There was a spark from one of the lights and then nothing.
    I replaced the switch on the wall, it is getting electric. All the wires inside the fan look good.the remote is indicating that is getting power from the battery when the buttons are pushed the indicating light goes on. So what is next.
    The lamp is from HD and it is 3 years old.
    Thanks
    Gary
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Jul 16, 2015, 05:41 AM
    "Spark from one of the lights" My suggestion is to make sure the circuit breaker / fuse is either OFF or Out. Then replace all of the light bulbs.

    Then restore power and let us know if that fixes the problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring hunter fan and light /light to 3 way and fan to on off wall switch [ 4 Answers ]

I now have both fan and light connected to a three way switch. It works fine. I would like to keep the three way with light, and use the fan on another on/off single switch. A three way duplex would do this. The question is, will I have to run another 12/2 line to the fan And can I use the other...

Replacement Hunter Fan/Light wall switch [ 1 Answers ]

I have a hunter 1912 Mission Bronze 54" fan with 2 lights, one above and one below the blades. The wall switch control has separate dimmer buttons for each light and hi, med, low, and off for the fan. Since a lightning strike the fan only works on hi or off but not on med or low. The light...

Wiring a ceiling fan with light from a wall switch [ 15 Answers ]

When I built my house I prewired a switch to the outside. My plan was to install a ceiling fan with light in and continue on with a flood light. What I want to do is to be able to operate the flood light from the wall switch and operate the ceiling fan and light from the pull strings only. I did...

Connecting ceiling fan and light to wall switch [ 3 Answers ]

The wall switch for my ceiling fan recently broke (it wouldn't change the speed of the fan anymore), so I bought a new one. The fan also has a light. The new wall switch instructions simply say to connect the blue wire to the fan red to the light, black to the HOT. Then the diagram shows a neutral...

View more questions Search