Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
What do I need to do to install the ground wire for my house on my copper water line?
 [ 1 Answers ]
 Please help! I am a 27yr old new home owner of 2 years living in Alabama and my water pipes froze the other day, so after the whole hair dryer thaw out time, thinking I'd done enough research, I went and bought foam pipe insulation and installed it. When I was down there I was covering the part... 
Can a bare copper ground wire be exposed in wall?
 [ 7 Answers ]
 I recently purchased a home with an outdoor shed. I've started to remodel the shed and I noticed that the sub-panel was wired incorrectly. Neutral and ground were attached to the same bus, and there was no ground rod. I've purchased a new bus bar for ground and I am in the process of installing my... 
Bare copper wire;
 [ 3 Answers ]
 Bare copper wire; Why do we use bare copper wire for grounding, why not all insulated? 
Using the ground or (bare) wire for the neutral wire
 [ 2 Answers ]
 I have a problem with some wiring that I ran for an outside motion light. Although the hot leg and ground wires are fine, the neutral wire is defective ( it may have gotten knicked or something). Of course, now the wiring is covered up behind a wall that I do not want to tear into if it can be... 
Is it okay to use bare wire as neutral?  Okay to share ground?
 [ 53 Answers ]
 
Our house was built in 2003 and it came with a GE 24" microwave oven that uses 120 volts/20 Amp. The microwave stops working so we went out and bought a KitchenAid convection microwave oven that requires 20 Amp, 240 volts, 60 Hertz. The old microwave oven uses 12/2 w/g romex from a subpanel. ... View more questions Search 
  |