Ask Experts Questions for FREE Help !
Ask
    chappers's Avatar
    chappers Posts: 10, Reputation: 1
    New Member
     
    #1

    Oct 29, 2006, 06:54 PM
    Circuit breaker failed to trip
    I made a big error today on wiring a new circuit. I pulled 2 cables (for 2 circuits) back to the consumer panel and then connected the wrong cable. The cable that I connected was stripped at the other end but not yet connected to anything. When I went to inspect it, I tugged on it and there was one short pop/spark/flash. I realized my error and went back to the consumer panel - the breaker to that circuit had NOT tripped. I am concerned as I thought that any arcing should immediately trip the breaker. Do I have a faulty breaker? Is it possible that my grounding is insufficient? Is there any way to test my breakers (without intentionally setting up s short circuit!)?

    A few details - the cirucit was 10/3 cable with a 30A breaker. The wires in closest proximity were the black and the ground.
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Oct 30, 2006, 03:52 AM
    I don't think the breaker is bad, is possible, but when the short occurred, the arc burns or melts the metal quickly, clearing the short, and if the short was not definite, the breaker saw it as a load, and allowed current to flow until the short did clear.

    There is no method to test a small breaker in the field, and is not practical to have a testing firm test a CB just for a routine event. If there was a fire involved and a CB was in question, then a testing firm would be hired to determine if a CB contributed to the fire.

    What you described is a typical high resistance short that cleared in a few cycles before the CB could react.

    Hope this helps and makes sense.
    chappers's Avatar
    chappers Posts: 10, Reputation: 1
    New Member
     
    #3

    Oct 30, 2006, 04:17 AM
    It makes perfect sense and I will sleep better at night. Thanks!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Circuit breaker [ 3 Answers ]

A circuit breaker connected to the kitchen tripped twice. I had an electrician in but the problem persists - in fact, the very day the electrician came. It does not seem to be caused by any one particular appliance. The first time I was using the waste disposal and the next two times nothing was...

Circuit breaker load [ 2 Answers ]

I'm remodeling my basement, & putting in a lot of elec'l outlets. Wondering how many outlets, or how do I figure how many, I can put on one ckt brkr. I'm using no. 14 Romex & 15 amp brkr. Tom :confused:

Circuit breaker popping [ 4 Answers ]

We just got a new refrigerator and the circuit braker for the air conditioning keeps popping. We live in Central FL by Daytona and it is really hot right now but we can't keep the air running. Help!!

Circuit Breaker Troubleshooting [ 4 Answers ]

I purchased an old farm with a water well. It was checked last summer with the pump company's pump (I assume they used their pump because there was no power at the property then) and it pumped well (15 gpm). Now I have electricity and tried to power up the pump. The fuses are the old...

Breaker doesn't trip [ 3 Answers ]

There is a property that has a 30-amp breaker in the electrical distribution panel labeled for the AC unit. The outside HVAC unit had a maximum over-current protection rating of 25-amps. I'm looking to see how serious this is and also to understand why the breaker doesn't trip with that amp...


View more questions Search