Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring Hot Tub and using a 50 Amp Double Pole GFCI Circiut Breaker
[ 10 Answers ]
:confused: I keep getting the GFCI breaker tripping after wiring my hot tub. I wired 2 hot Red and Black to the proper terminals and the White to the neutral and the Bare Copper to the ground Post at the tub. I am using 6-3 w/G per instructions. Could the GFCI breaker be bad? When I wire...
20 amp double pole gfci
[ 9 Answers ]
I am working on an addition and am installing a whirlpool tub. The tub requires 2 - 20 amp GFCI protect circuits: 1 for the pump and 1 for the heater. I ran 12/3 wire in the walls thinking I could have the BLACK wire go from 1 GFCI breaker to the pump outlet and the RED wire go from a 2nd GFCI...
Amp hookup
[ 2 Answers ]
I have a new car with a good stereo system in it but it doesn't have the preamp outputs for the rca cables is there another way to hook my amp and subwoofers up to my stereo? If so how can go about doing it.
Installing double pole wall t-stat baseboard heater
[ 2 Answers ]
I have a 220 baseboard heater, and it is on dedicated circuit. Heater works okay as I have run wires straight through and turned on circuit breaker and heater works. This is a Marley baseboard heater and wall double pole thermostat. Instructions with thermostat leave a lot to be desired. Actual...
Amp sub hookup
[ 1 Answers ]
My sub is a kicker s15 15 inch 1500w solo baric. What wattage should I get for an amp? View more questions Search
|