Ask Experts Questions for FREE Help !
Ask
    klezmire's Avatar
    klezmire Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 23, 2012, 08:34 PM
    Will a Submersible Pump which runs on 3.6amps function at all at 600mA?
    I'd like to submerse a pump for a water feature (fountain) and power it off a solar charge meant for small electronics (iPhones, such).

    The pump asks for 3.6amps... The charger creates 600mA...

    Here's the thing. I don't need to use the 1/5 horsepower pump to full potential... I don't want to shoot water 5 feet above the fountain!

    So, will the limited power force the pump to work slower, less optimally, or will it fail to reach an "activation?"

    Thanks!
    sinnadurai's Avatar
    sinnadurai Posts: 127, Reputation: 2
    Junior Member
     
    #2

    Sep 24, 2012, 01:49 AM
    Do some calculations and decide the rating(Ah,Volt etc) of the battery required to power the pump and charge it by the PV array. Depending on the rating of the array you can calculate the runnning time of the pump without allowing it to discharge more than 50% of the charge.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Comparison between jet pump and submersible pump [ 2 Answers ]

I have a 300 feet deep bore well. Water is to be stored at 3rd floor level above ground. Which type and capacity of pump would you suggest for use?

Submersible pump runs but doesn't pump. [ 4 Answers ]

The water to my house quits periodicly. When it does this, I have tested the power to the pump and no probem. Also, I can hear the pump running but there is no pressure. I can shut the breaker off for a few seconds then turn it back on and it will pressure up normally. There is no indication of a...

Two questions pool pump & submersible well pump for irrigation in river [ 3 Answers ]

Have a inground pool about 5 yrs old that we replace motor every yr,the wireing & amount of juice is OK it's the sealed bearings that start squealing an freeze up, 2ND ? The well pump is 220v / 2 wire direct to breaker ,its on or off nothing fancy an has worked for years except this yr ,runs...

My submersible pump runs but drains back into the well? [ 1 Answers ]

My submersible builds pressure but drains right back into the well. I can feel air coming out of the top of the well casing when it drains back into the well quickly. Why is this happining

My submersible pump runs but drains back into the well? [ 0 Answers ]

My submersible pump builds pressure but then drains back into the well and kicks on again. Why is this happening.


View more questions Search