Ask Experts Questions for FREE Help !
Ask
    drhlrh1230's Avatar
    drhlrh1230 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 28, 2013, 03:29 PM
    How to wire 3 phase 1200 amp120/208 with CT panel
    How to hook-up 1200amp 3 phase with ct metering?
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
    		  
    #2

    May 29, 2013, 04:07 AM
    Well, that's a big question...
    First, where is the project location? Is this service for a single owner with (1) utility meter?
    Who is the Electrical Utility?
    Most important... what is the calculated demand load of the property? You will need this for the Utility...
    And please be more specific with your question(s)...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a 208 3 phase panel from which I need to operate a 208 volt sigle phase motor [ 2 Answers ]

I have a 208 3 phase panel from which I need to operate a 208 volt single phase motor. Is there any way to get the correct single phase voltage without using a transformer?

Can you get single phase 208(2 legs) from 3phase4wire120/208 panel [ 2 Answers ]

I have an air compressor rated 230/460. I only have available 3phase 4 wire 120/208. Can I use a 2 pole breaker and get 208, and then use a boost transformer to reach 230, or will the compressor operate effeceintly enough with 208 using the 5% rule for operating voltages?

Can I get 230 volt from a 120/208 3 phase panel? [ 2 Answers ]

I have a120/208v 3 phase panel and I need to plag a 230v motor ,this it possible?

3 phase 208 volt panel 11000 kw what size breaker to use [ 1 Answers ]

I have a 3 phase 208 volt 11kw oven. What size breaker should I use. Is it 208/11000 which would be 50 amp Or 240/11000 which is 45 amp. Current power source is 208 volts and currently has # 6 wire

How to wire single phase 208 wiring [ 1 Answers ]

I need to power up a unit requiring 230 VAC single phase. The lab power is 230/3 phase and standard 120 VAC single. What is the correct way to wire this?

View more questions Search