What is the max size (amps) sub panel I can run off a 200A main?

ccmack2 Posts: 1, Reputation: 1

New Member

Nov 9, 2010, 03:07 PM

What is the max size (amps) sub panel I can run off a 200A main?

tkrussell Posts: 9,659, Reputation: 725

Uber Member

Nov 11, 2010, 04:03 AM

Depends on the make and specifications of your panel. The label on the door will tell you the max branch circuit breaker your panel can handle.

Add your answer here.

Check out some similar questions!

I am hooking up a Hot tub with a max fuse size of 50 amps. [ 3 Answers ]

I am hooking up a hot tub rated for a 50 amps max fuse size. I already have the #8 thhn and 1/2 liquid tight flex conduit. Will the #8 wire be enough for 50 amps.

What size should the neutral be if I run a 200A service using #1 copper? [ 4 Answers ]

I am running 2, 100 amp disconnects off a 200 amp disconnect. The run is 100 feet long. I am told that I can use #1 copper for the power lines. What size should the neutral and ground wires be for this run?

Feeder size for 200a sub panel [ 1 Answers ]

What I have is an added 2 car garage with a game room added and connected to the main house. Problem is the main service had to be moved to the exterior of the new garage. I picked up this job after someone else bailed on it. Anyway its been decided to put all the existing circuits into a 200a sub...

Wiring into a new main panel (200A) and sub-paneling our existing 100A [ 8 Answers ]

I have been told that it is possible to install a new 200A main panel near our old 100A main panel, install a new weather head and when I have the power company switch the power to the new panel, then setup the old panel as a sub panel of the new. One of my main concerns is that the old panel...

Max Amps in a Panel and adding a sub panel for more circuits [ 3 Answers ]

Hello all, I recently moved into a condo with a 200 amp panel (in my unit). The main panel is in the electrical room of the building and my unit was previously a commercial retail space. I did some remodeling and my panel is now full. The total combined amps of all the circuit breakers...