I have a 220 welder plugged into a 30 amp breaker and a 50 amp rated plug. I just bought a 220 compressor and was wondering if I could make or have made a short cord with an adapter to plug into the 50 amp plug?

What would cause one wall outlet in living room, 2nd fl hall light and outside house light not work. Checked breakers - no issue with them. Then 2 months later the power comes back on

Can you have a 480 volt primary transformer feed in the same pipe with 120 volt Branch circuits. Can you share a under ground vault with 480 volts and 120 volts arriving and leaving in separate conduits.

I would like to know the cost of installing a single lite switch a single receptacle in afinished wall made of lathe and plaster. Going to my basement. Wire usage would be about 40 ft. my box is in the basement the sw is going to 3 small can lites over a bar a box was built for them. The receptacle...

I have installed 6 insulated can ceiling lights. They are on one circuit controlled by a Levaton paddle switch with a slide dimmer rated at 600w.The bulbs are phillips 60 watt halogen spots for a total wattage of 360w. They have worked fine for about a year usually run at about halfway on the...