 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wood Repair of Fascia Board
Piece of wood is unmovable. Only edge of wood is careworn.
Some have suggested Glazing Compound, Glazing Putty and wood dough. After it dries, you can sand it. Your thoughts? |
||||
|
|
|
||||
|
Cut worn section out and replace with a piece of wood same size. Put glue on edge and screw piece up from bottom. Fill seam with wood putty, sand when dry, prime and paint. Patch will be near invisible.
Chuck |
||||
|
|
|
||||
|
Use sheetrock mud
|
||||
|
|
|
||||
|
Taping compound (sheetrock mud) is water soluble and is not designed for outdoor use.Will fall off in short order.
Chuck |
||||
|
|
|
||||
|
Agreed. Even interior/exterior wood putty is a cheap fix compared to CPES and two part epoxy.
|
||||
|
|
| Question Tools | Search this Question |
Check out some similar questions!
The fascia boards,banana cut look, on my house are nailed to rafter ends that are cut square to rafter. This creates a compound angle at butting ends at the inside/outside corners. How do I cut these?. David
Where is is located? Is this potentially the issue if the fan blower will not stop. This is a wood furnace
Bevel cuts not lining up at the corners. After being cut by saw the two pieces lined up. 45"bevel cut. But upon installation on the house. They do not join correctly. Do I need to shave off one board.25876
When installing board and batten wood siding on my garage do I put the rough side of the wood facing the inside or outside of the building Thank-you Brian
Where can I buy a metal bracket to repair a wooden fence post?
View more questions Search
|
