Ask Experts Questions for FREE Help !
Ask
    bialachowski's Avatar
    bialachowski Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 21, 2007, 10:40 AM
    Installing a shower on an outside wall
    My husband and I are building a shower, we would like to have a shower head on either side of the shower, but one of the walls is an outside wall. We live in the Chicagoland area and are worried about the pipes freezing. Is this a reasonable scare?

    Thanks.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Mar 21, 2007, 11:28 AM
    Yes, modern building techniques in our beautiful climate avoid plumbing on outside walls unless you are using 2x6 construct with more than minimum insulation. Years ago mom and dad had to leave the sink cabinet doors open in the winter so they would not freeze. Things are better now but go with the inside wall if it can fit your design. Hey, is it going to be 60 today so no more worries, right?
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
     
    #3

    Mar 21, 2007, 11:52 AM
    You are correct to be concerned. Dig back to February here in the plumbing forum and you will find numerous threads of water being off. It is quite common to run water lines in outside walls. If the outside sheathing is tight enough to keep out the outside air, and the insulation properly to the outside of the pipes, it should be fine. I suspect most of the problems comes from sloppy work when the house was built. Me, before closing the wall back up after installing the pipe, I would add one of those foam insulating tubes over the pipe. I think the better, closed cell stuff is $3 for 8'. With a little care, it should be fine.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installing a wall oven [ 6 Answers ]

Hi - replacing my Moffat wall oven with a neighbours GE wall oven/convection oven. My service has your traditional 4 copper wires - red, black, white and ground. The Moffat had four - it was an easy match. GE oven has FIVE - red, black, white, green and BLUE. I know what to do with all the...

Installing a base molding to a wall that has metal stud [ 4 Answers ]

Hello, I am looking for help on installing base molding, and so far everything I have seen tells you to install the molding to the wall by nailing it to the stud. My question is; what happens if the stud in the wall is metal, would that nail hold securely in the metal stud? If not what...

Installing a new wall oven [ 1 Answers ]

We are upgrading to new appliances in our 60's something kitchen. The new wall oven has red,black, white and bare copper wires in the armored cable. My old oven only used black, white and bare copper. I assume the black and white are both hot. Should I connect these to the black and red at the...

Installing Telephone wall outlet [ 1 Answers ]

I'm having trouble installing a telephone wall outlet. The wire has 6 wires and the outlet has 4 wires. HELP!!

Installing new wall heaters [ 16 Answers ]

We currently have radiant heat. We must change over to electric wall heaters. My question spans the installation of the new heaters and if it is possible to use the existing wiring without rewiring and tearing into the sheetrock. I have outlined what we want to do. Any input as to if this is...


View more questions Search