Ask Experts Questions for FREE Help !
Ask
    oilman's Avatar
    oilman Posts: 3, Reputation: 1
    New Member
     
    #1

    Apr 3, 2007, 08:18 AM
    Door installation
    What size opening do I need in CB construction for a 3'-0 entrance door?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Apr 3, 2007, 08:31 AM
    If you are using a 36" door you'll need to allow for the door frame and shimming. 1" to 1 1/4" should be sufficient on both sides. Shim under the hinges first until plum. Sim on the lock side top, bottom and lockset until plum. I am getting lazy and tend to go with pre-hung doors.
    glavine's Avatar
    glavine Posts: 895, Reputation: 87
    Senior Member
     
    #3

    May 19, 2007, 10:51 AM
    Rough Opening Is 38 1/2 For The Width. Its Always 2 And A Half Inches Bigger That The Door, Some Will Be Just 2" But It All Depends On The Studs And If There Plum Or Not. If Not Youll Want That Extra 1/2"
    Hope This Helps , Nichols Trim And Carpentry

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Shower door installation [ 4 Answers ]

I built a new bathroom in my basement and am now preparing to install a shower door. The door will be installed over 12x12 ceramic tile on top of cement wonderboard. To install the track to the walls, the instructions say to drill holes through the tiles with a 5/16 mansonry drill bit. My...

Glass shower door installation problem [ 7 Answers ]

My contractor put in an entire new shower for me, including the walls, fixtures, tile, etc. There is a glass shower door between two tiled half walls (and then glass going from the half walls on up). The glass is frameless except for where the glass meets the tops of the half walls. When the...

Millikin Door Kit needed in order to install storm door [ 1 Answers ]

Hi. I have a Milliken (may be mis-spelled) exterior door with two side light panels on both sides. I have purchased a Larson Storm Door for the front door. There is not enough depth between the two doors when measuring them - therefore I need to build the front door frame out. I need to know...

MayTag freezer door opens when refrigerator door is closed [ 2 Answers ]

Hi, I'm new here. I have a 9 year old Maytag refrigerator with a freezer on top. Recently whenever I close the refrigerator I notice that the freezer door pops open. I looked at the seals around it but can't see anything wrong. I did notice that I can simply tap on the door and it will...


View more questions Search