Ask Experts Questions for FREE Help !
Ask
    johan danial's Avatar
    johan danial Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 15, 2012, 06:42 PM
    My monitor won't start what should I do?
    It works fine as I was doing my assignment and then the monitor won't start.. tried everything but it seems that the problem is still there.. what should I do.. :S
    ComputerHelpers's Avatar
    ComputerHelpers Posts: 49, Reputation: 3
    Junior Member
    		  
    #2

    Nov 22, 2012, 10:59 AM
    Unplug from wall wait 2 min plug in again then reconnect to computer sometimes it's a lockup of screen saver or energy saver
    sirthomasrules's Avatar
    sirthomasrules Posts: 13, Reputation: 1
    New Member
    		  
    #3

    Nov 23, 2012, 09:38 AM
    What you need to do is if the fuse has gone or the wiring once if these don't work it might be a good idea to get an computer engineer or get a cheap one for the time being for it.
    cmeeks's Avatar
    cmeeks Posts: 754, Reputation: 64
    Senior Member
    		  
    #4

    Nov 25, 2012, 05:56 AM
    Check your cable connections unplug and replug at both ends then restart if this dode not work try a different monitor to dee if it is the monitor or the computer.
    joypulv's Avatar
    joypulv Posts: 21,591, Reputation: 2941
    current pert
    		  
    #5

    Nov 25, 2012, 06:49 AM
    I had a monitor that would go black because there was a loose wire inside the cable, which was crimped from being at too much of an angle. I had to wiggle it to a more straight down position. Later replaced it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Capacitor-start induction motor won't start, kind of runs... help [ 3 Answers ]

1/2 hp Capacitor-start induction motor, reversible by manual switch, cap is good, centrifigul throw out is good. I believe the thermal overload may be bad. Motor will hum but not start. If I start it by hand (in either direction) it will run till the centrifigul throw out kicks in then shuts...

Won't start-deck engage switch is causing it to start or not start [ 0 Answers ]

I must engage deck plunger several times to get the tractor to start sometimes it never starts 1 year old-aprill 2011

74 chevy truck will turn over but won't start. Will start with starter fluid but won't [ 1 Answers ]

My 74 chevy pickup sat over the winter and now it won't start. I was running just fine before I let it sit. It turns over but won't start. If I use starter fluid, it will start but won't stay running. I don't smell gas in the carb either. I'm thinking it's the fuel pump or the filter. Problem...

my john deere z 425 won't start, it turns over but won't start [ 0 Answers ]

my john deere z 425 won't start, it turns over but won't start. I keep turning it over but it never cranks. It only has 150 hours on it

'97 toyota tercel won't start it turns the motor over but doesn't want to start? [ 3 Answers ]

I have checked fuel pump and changed spark plugs. I have know idea why it won't start or is hard to get started. When it does finally start it runs great so I think that would rule out the timing belt. If you have any suggestions I would appreciate it.

View more questions Search