Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Thermostat wiring connector - where do the wires go?
[ 5 Answers ]
I'm trying to install a new Honeywell thermostat for my heating/cooling system. The old one had screws that held the wires in place. The new one has a connector with a set of holes facing up (one pair jumpered) and a set of holes facing out, and tiny screws in between. I think you stick the wire...
MAP sensor;Mass Airflow sensor;Volume Air sensor-All Same?
[ 8 Answers ]
97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...
Kenmore Dryer not heating -wire connector discoloration
[ 8 Answers ]
Hi, I have a Kenmore Dryer not heating but spins and appears to be working fine. I've visually check the heating element and don't see any breakage on the coil. I do see wire connector discoloration on the two thermostat , (hi-limit tstat and operating tstat). I'm planning on replacing both. Do...
Which connector for laptop to external HD
[ 1 Answers ]
Anyone know the correct name and designation of the cable for connecting an IBM laptop to an external hard drive?
Shower push-in connector problem
[ 2 Answers ]
Hi, I'm trying to install a new electric shower unit, it has a type of connector to the mains water called a 'push-in' connector. No matter what I try this seems to leak. The instructions just skip over it, and don't give any more instruction than how to disconnect it. I can see how it's... View more questions Search
|