Ask Experts Questions for FREE Help !
Ask
    hconnickjr's Avatar
    hconnickjr Posts: 3, Reputation: 2
    New Member
     
    #1

    Jul 12, 2010, 12:12 PM
    Toyota engine knock overheat sequoia
    I have an '02 Sequioa Limited. The check engine light (along with traction control lights, as I understand is normal) came on while I was driving, then the engine started knocking a couple of minutes later at highway speed My temp gauge went redline. I pulled over, let it cool for 30 minutes, checked fluids and restarted. My oil was at the appropriate level and coolant was not low.

    Engine still knocked very slightly for about 1 mile, but temperature was fine. 1 mile later and no knocking or temp issue, but the same 3 lights were still on.

    I was 30 miles from civilization, so I continued to drive with no issues (temp was normal, no knocking) except the same warning lights when my engine began to knock loudly, the radiator popped and sprayed coolant all over the front of the vehicle and my windshield. The temp gauge was still normal. I immediately shut it off, stopped there and had it towed the remaining 25 miles.

    I'm nowhere near an import mechanic, any ideas or suggestions as to the cause of this? Even to move my car onto the road for the tow truck, it sounded fine with no knocking issue whatsoever.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Jul 12, 2010, 12:20 PM

    . Check for codes--the information will be crucial.

    . Read the links below:

    https://www.askmehelpdesk.com/cars-t...tml#post235973

    https://www.askmehelpdesk.com/cars-t...ml#post1365453

    Phosphate scale can easily block passages, requiring the radiator to be changed. Only use a 50/50 mixture of Toyota recommended antifreeze and distilled water.

    . kitch428 is our Toyota expert. He works for Toyota and will pounce on this thread, as soon as he gets home.

    . To protect your car, in the future, only use full-synthetic engine oil. Toyota will soon be requiring it:

    https://www.askmehelpdesk.com/cars-t...ml#post2059400

    Synthetics have a higher coefficient of heat, which allows engines to run cooler. In emergency situations, you need all the protection you can get.

    Cooling system problems are usually caused by a lack of proper preventive maintenance. Attention to details makes all the difference in the world on modern-day vehicles. My bet, from afar, is that minerals in the tap water formed phosphate scale, which blocked the radiator. It could be catastrophic water pump failure--however, I would be somewhat surprised. My father's Toyota Tacoma died due to head gasket failure. Keep us posted with the solution.
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
     
    #3

    Jul 12, 2010, 03:39 PM

    Definitely a cooling system malfunction. Water pumps go bad all the time. Especially when aftermarket parts are used. Could be as simple as a faulty thermostat, or something major such as a head gasket.
    You will most likely have a temp related code(s) stored along with ABS/VSC Trac off lights (which is normal as you mentioned)
    The shop should be able figure it out for you. It was a good thing you decided to tow it. Cheap insurance.
    Well written post, hconnickjr. I wish all would post such useful information as you did. We will be glad to be of any help. Just chime in right here at this post.
    hconnickjr's Avatar
    hconnickjr Posts: 3, Reputation: 2
    New Member
     
    #4

    Jul 14, 2010, 12:43 PM
    Thanks for all of your prompt responses. What an awesome group this is! When I heard the knocking, I was pretty worried about the many things that could be wrong.

    Here's the scoop. Kitch you were exactly right, it was simply a thermostat which caused the engine to overheat and, in turn, the knocking in my engine. I have no idea why the gauge showed a normal temp right before it popped, but they ended up repairing the hole in my radiator easily enough. I requested that they use the 50/50 Toyota recommended antifreeze as GreaseMonkey suggested and I will switch to full synthetic on my next oil change. The more that I researched it, after your comment, it makes sense and is a small price to pay for the extra protection.

    I'm glad I got it towed either way. I really really appreciate your help and I will stay tuned to the posts on this site. I may not be a lot of help right now, but I'll learn and contribute all that I can.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #5

    Jul 14, 2010, 12:52 PM

    Nice going. Thermostats often stick due to mineral build-up, too. Just make sure they use distilled water with the antifreeze. Change the coolant every 2 to 3 years or 30,000 miles, whichever comes first.

    Your story had a happy ending, unlike many of them on this site. Towing likely saved you big bucks!
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
     
    #6

    Jul 14, 2010, 01:29 PM

    Great news! Here's the 'why' you saw the gauge showed normal right before it popped.
    The engine coolant temp sensor must 'see, touch, feel' the coolant. If it's an air pocket, which you most likely had, then the accuracy of the gauge is not correct.
    That should set you straight and possibly help others that come across this post.
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
     
    #7

    Jul 14, 2010, 06:27 PM
    Quote Originally Posted by kitch428 View Post
    Great news! Here's the 'why' you saw the gauge showed normal right before it popped.
    The engine coolant temp sensor must 'see, touch, feel' the coolant. If it's an air pocket, which you most likely had, then the accuracy of the gauge is not correct.
    That should set you straight and possibly help others that come across this post.
    Very good point again, Kitch!
    djbarton's Avatar
    djbarton Posts: 2, Reputation: 1
    New Member
     
    #8

    Dec 31, 2010, 06:22 PM
    Well I saw this post and was like. DID I post this. This happened to my 2005 SR5 Sequoia. I had the radiator, thermostat and hoses replace and it ran good for 1 month and now it's over heating again, to the point when I turned it on it was overheating within 5 minutes of idle. I had all the repairs done at Toyota Dealer and they said that the Water pump was fine. I don't think it is but what else could it be?
    kitch428's Avatar
    kitch428 Posts: 1,440, Reputation: 152
    Ultra Member
     
    #9

    Dec 31, 2010, 07:22 PM

    I'm sure others would agree, take it back!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

2003 toyota sequoia,check engine light on,& trac off lighton.&vso trac light on. [ 16 Answers ]

2003 toyota seuoia. Check engine light on.and traco off light on as well as vso trac light on. I had in shop 4 weeks ago same problem they said it was gas cap not on tight, I tried that today but did not make light go off, help if you can thank you dan

2001 Toyota Sequoia not starting [ 8 Answers ]

Hello, My friend has a 01 seqioua she let it sit there for some time "Probably 3 Months" In the driveway. So I was telling her to use it. When she was trying to start it there was nothing it was not cranking, I didn't even hear the starter. I started it 3 months ago and it started. But now its not...

Loction of the Knock Sensor on 1994 Toyota Camry [ 3 Answers ]

I replaced the head gasket on a 1994 Toyota Camry 4 cyl and now get a Check Engin code 52 which is a Knock Sensor indication. I cannot find the Knock Sensor. Can you explain where it is?

Where are the knock sensors on a 2000 Toyota Avalon [ 1 Answers ]

Where are the knock sensors on a 2000 Toyota Avalon v6 and what must be removed To replace them.

'94 Toyota previa knock sensor code [ 8 Answers ]

I was brought a '94 Previa w/ a 2.4L, no super charger, that overheated blowing the head gasket. The head received a valve job and was reinstalled w/ new plugs, wires, efi temp sensor, and thermostat. All timing marks are lined up. The rotor in the distributer seems a hair off from #1 wire at...


View more questions Search