Alternator solenoid valve fuse blowing with 1990 Honda Civic

scott1111 Posts: 1, Reputation: 1

New Member

Nov 8, 2005, 06:57 PM

Alternator solenoid valve fuse blowing with 1990 Honda Civic

A frined (I guess you could cal him that) gave me a 1990 Honda Civic that doensn't run... two problems: one problem is that the fuse to the alternator solenoid valve blows when I turn the key to start thus I can't get the codes from the EUC.. the other one is that there is no fuel getting into the fuel injectors... I am pretty sure that it is an electrical fault... any help?? Suggestions? Thanks...

Check out some similar questions!

92 Honda Accord, A/C Fuse keeps on Blowing out. [ 9 Answers ]

I have a 92 honda Accord EX. The A/C fuse (7.5A) (under the steering wheel) keeps on blowing out. Every time I replace it, it cools the car for 5 minutes and the A/C fuse is blown out again. I am not sure where to start diagnosing the problem. Any suggestions would be highly appreciated. One of...

1990 honda civic duel point infection [ 16 Answers ]

My son dropped his car in my driveway about a month ago. He had just had the fuel tank replaced but was also having problem keeping the car running and it would stall at traffic lights. He asks them to check it out. They said they would have to change the tank first before the engine could be...

1990 Honda Civic fuse problems [ 3 Answers ]

I am trying to get a 1990 Honda Civic to run. I am looking at the fuse panel under the stearing wheel. There is no cover. I am missing 6 different fuses. I think one of them might be to the fuel pump. Can any one tell me what amp fues goes in each slot, and which one goes to the fuel pump?? Where...

1990 Honda Civic won't Start [ 9 Answers ]

Hello, I am totally stumped with this, I have a 1990 Honda Civic with a 1989 Acura Integra Engine in it (Engine Swap), and it won't start. Nothing works, the lights, the radio, hazards, defogger absolutely nothing. Of course your thinking the battery is dead but I checked the battery and it...

1990 Honda Civic DX [ 3 Answers ]

Here is my problem: My engine starts and idles fine. Under acceleration it accelerates up to about 2500 rpm, then the ignition cuts off. When you shift gears you can run it back up to about 2500 rpm again, then it cuts out again. This occurs through all the gears. The check engine light stays on...

View more questions Search

Check out some similar questions!

Add your answer here.