Ask Experts Questions for FREE Help !
Ask
    rfathers5's Avatar
    rfathers5 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 29, 2006, 11:24 AM
    No Heat/94 Ford Ranger
    The heat in my 94 Ford Ranger stopped working. The blower blows, but the air is cold instead of hot. We've changed the radiator, thermostat, heat sensor unit, heat sender unit, checked operation of heat control(doors work ok), still no heat. Engine does not reach operating temperature-HELP!!
    Also, doulble-checked the installation of thermostat-ok
    dodgedriver1's Avatar
    dodgedriver1 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Oct 29, 2006, 03:08 PM
    Quote Originally Posted by rfathers5
    The heat in my 94 Ford Ranger stopped working. The blower blows, but the air is cold instead of hot. We've changed the radiator, thermostat, heat sensor unit, heat sender unit, checked operation of heat control(doors work ok), still no heat. Engine does not reach operating temperature-HELP!!!
    Also, doulble-checked the installation of thermostat-ok
    You could need a new heater core
    ccross5882's Avatar
    ccross5882 Posts: 1, Reputation: 1
    New Member
    		  
    #3

    May 9, 2011, 06:34 PM
    I had the same problem with a subaru, and I'm having it now with a 94 ranger. The fix was to park the car on a hill face up the hill when you fill it because the top radiater hose is higher than the filler tube you end up with a big air pocket. It worked on the subaru, I'm in process of replacing the radiator in the ranger but I'm sure that will fix it. Good luck!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ford Ranger [ 1 Answers ]

2001 Ranger. I found dangling down from left side rear a hose with a cilp. It was attached to the axle housing. What is it for and where does it go. It just appears to be some type of air hose but is not attached to anything at other end. Should I be concerned? Thanks

92 ranger won't start [ 2 Answers ]

I have a 92 ford ranger with a 4 cylinder Distributorless ignition. It has gotten to where it just cranks and doesn't fire. Changed plugs and wires and still nothing. Any easy way to check the coil packs to see if they are bad? Or what else could it be?

Ford ranger A/C problem [ 3 Answers ]

I recently purchased a 93 ford ranger the clutch for the air conditionaer won't engage. The low pressure switch checks out good the fuses are good and the relay seems to be working but I am not getting any voltage to the compressor and ideas.

My ford 2.3 in a 91 ranger [ 3 Answers ]

Hey guys my problem is that I just swaped out a 2.3 for another 2.3 and when it runs it idles fine for a little bit then it seems like starts to miss then boggs out and dies and back fires like a cannon so bad it blew a brand new muffler out of round it kind of seems like it gets a rich smell of...

View more questions Search