Ask Experts Questions for FREE Help !
Ask
    DeMan2319's Avatar
    DeMan2319 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 27, 2017, 02:09 PM
    Installing a sound system?
    Good evening everybody. I have a few items to install for an Audio System upgrade; but don't know how to go about it. The Items that will be involved are -1 Distribution Block -2 Amps. -1 Capacitor. -1 Equalizer/Crossover -6 Speakers in Total (2 tweeters, 2 Front Door 6.5's, and 2 6x9's) -1 Subwoofer

    I'm trying to connect 2 amps; 1 for the Subwoofer and the Second for Speakers. My Aftermarket Head Unit has 3 pairs of RCA plug-ins.
    1) Subwoofer 2) Front 3) Rear.

    How Would I connect the 6 speakers (which I'm going to rewire) to the 1st amp? Do I wire the Speakers to the Amp or Straight to the Head unit itself? Also, how would I connect the amp to the Head unit if it only has the 3 RCA plug-ins as stated above?

    Any advice or suggestions are Welcomed. Thanks in advance.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Dec 29, 2017, 09:16 AM
    Can you give models of the equipment, You may need to do a series/parallel with the speakers to maintain the Impedance.
    Need Impedance of Speakers and Amps Impedance.
    talaniman's Avatar
    talaniman Posts: 54,327, Reputation: 10855
    Expert
    		  
    #3

    Dec 29, 2017, 10:54 AM
    I found this interesting blog site that may help you synch your amps/speakers for good effect.

    How to sync two different amps - Amplifiers / Head Units / Processors / Electrical - SSA Car Audio Forum

    And this gem,

    https://www.rigolna.com/products/dig...content=DS2000

    Or go pro

    https://www.sweetwater.com/store/det...7_t-1514569965
    DeMan2319's Avatar
    DeMan2319 Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Jan 2, 2018, 01:40 PM
    Thanks for commenting.. I have the Big 3 upgrade. As for equipment; it goes as followed:
    Head Unit: Kenwood. KDC-BT555U
    Equalizer/Crossover: Lanzar Vibe XE3
    Distributor Block: Scosche.
    Capacitor: Tsunami 2 Farad 20VDC

    As for Amps; I have a variety which Consist of...
    Dual XPR52 (2 Channel Amp.)
    Kicker DX-A250.1 (2 Channel Amp)
    Mmats Pro Audio E600.4 (4 Channel High Power Mosfet Amp)
    Boss CH2502 (2 Channel Mosfet Power Amp)

    Speakers: 2 Boss Tweeters, 2 6.5's Orion HCCA with Red Housing Door Speakers, 2 6×9's Almani in the Rear Deck.
    Subwoofer: MTX Thunder US-XT10-04

    Thanks again for everyone taking part in my assembly!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

No system sound [ 8 Answers ]

Hello I can't hear any system sound it was OK a few months ago but now nothing, I can still play cds and hear them perfectly. So I know my speakers are working, I have checked the cables and mute volume and all are fine. My operating system is xp. Hope someone can help please Regards

How do I get the sound system [ 2 Answers ]

Check to see if the sound card is properly recognized by the PC. Go to Control Panel - System - Hardware - Device Manager - Sound, video, and game controllers To make sure it shows the devices and drivers something like the attached image. But, nothing happens... Please help me solve the...

Installing shallow well system [ 4 Answers ]

I bought a lot with a well. The hole is there but no pump are tank. I need to know how to install the pump , pressure switch ,and tank. I will be using a diaphram tank.any help would be appreciated.

Sound on my computer stopped working after installing xp [ 3 Answers ]

I'm trying to find out how to get the sound on my computer to work again. I used to have windows 2000 and the sound worked fine... now that I have installed windows xp... no sound. Help!

Installing CMI8330 sound card on Win XP [ 1 Answers ]

I just loaded Windows XP professional on my PII 333 MHZ system. The system board is SIS620 with built in CMI8330 sound card. The sound driver supplied with CD is compatible with win NT. Please let me know which driver to install to enable my sound card on Win Xp. I am also running win 2000...

View more questions Search