Ask Experts Questions for FREE Help !
Ask
    Grogan's Avatar
    Grogan Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 6, 2012, 06:53 AM
    Honda mechanic need answers for free
    I have a little dash board engine light problem I got a diognostic done first showed up lamba sensor 2 so I changed it, then it showed up sensor 2 but I changed that a few months back. I tried resetting it by computer but it keeps coming back up an answer would be greatly appreicated.
    Grogan's Avatar
    Grogan Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jul 6, 2012, 07:04 AM
    Honda mechanic need answers for free
    I drive a 01 honda older shape I had a diagnostic done showed sensor 2 so I changed it then its showing up sensor 1 but I had that changed a few months.I tried knocking it of by computer but its staying on.Any suggestions would be greatly appreciated.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #3

    Jul 6, 2012, 07:05 AM
    Ensure that you changed the downstream sensor, located in the catalytic converter. Also, ensure that the new sensor, connector, or wiring was not contaminated with oil, antiseize compound, brake cleaner, or WD-40, for instance. If the connector got contaminated, it will throw a code forever. After that, clean the connector with Swiss jeweler files. Are you sure the catalytic converter is good? Did you use a code reader or scan tool to clear the code? Disconnecting the negative battery cable may not work. Finally, only use Denso oxygen sensors, not Bosch generics.
    beded22's Avatar
    beded22 Posts: 1, Reputation: 1
    New Member
    		  
    #4

    Jun 5, 2013, 10:09 AM
    Sometimes my 2001 honda accord won't start. It cranks but won't turn over. If I come back an hour later it starts up. What could be the problem?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #5

    Jun 5, 2013, 11:00 AM
    beded22, replace the Ignition Control Module (ICM) and coil inside the distributor.
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
    		  
    #6

    Jun 7, 2013, 05:56 PM
    Not trying to be a smarta$$ but, A Honda Mechanic would know the answers to this or at least have accessibility to the tech manuals necessary.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ask a honda mechanic free [ 18 Answers ]

I have a 94 civic with projector head lights and when I turn the head lights on the passenger blinker stays lit. but when the headlights are not on than everything works fine. What do you think could be causing this?

Ask a honda mechanic for free? [ 2 Answers ]

I have broken lugnuts on a single tire a total of three times them last time they checked the suspension and stated everything looked OK. Even though they changed the lugnuts every time I break my tire makes a grinding clicking noise and no one can figure out what's wrong! Have spent over 200...

Ask a Honda mechanic for free? [ 0 Answers ]

How to install sirius radio into 2008 honda ridgeline

Ask a honda mechanic for free? [ 1 Answers ]

If I take my throttle body off would I need to replace its gasket when I put it back on?

Free answers to honda civic problems? [ 0 Answers ]

Had routine oil changed on 2006 Civic at dealership. Oil appeared to leak following this service (evidence on surfaces under car). Took car to independent mechanic that discovered the Honda dealership that changed the oil did not put washer back in place; had to drain newly replaced oil and add...

View more questions Search