Ask Experts Questions for FREE Help !
Ask
    cb7witbass's Avatar
    cb7witbass Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 23, 2008, 04:30 PM
    3000 rpms at 65 mph?
    I have a 1991 accord ex (auto) with 320,000 miles on it.. I bought it about 2 years ago wit about 22,000 less miles on it.. since I had the car the (S) light blinks and I hooked up a jumper wire and it gave me a code 9 (No. 1 Cylinder Position Sensor (CYP)) and I guess it doesn't have the final gear because my rpms are at 3000 when I'm only doing 60 mph. someone said the cyp is in the distributor so I would need 2 change it.. I went to the junkyard and bought tha cleanest 1 I could find.. same problem.. code 9. I don't even really car about the code unless its going to give me my final fear bak. Could anyone help me with this situation?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Dec 23, 2008, 05:28 PM

    You've obviously gotten your money's worth from the car. At a minimum, I would install a new genuine Honda distributor housing. With a bad CYP sensor, I doubt anything else will solve the problem. You can try reusing your existing ICM and coil, but I would install new ones.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

96 cadillac sts rattling sound at 2800 rpms why [ 1 Answers ]

I recently purchased a 96 cad sts and it has 200,000 miles otherwise perfect cond. Prior owner used premium gas which is required. I was cheap started putting cheap gas in and I just started hearing a rattling noise at about 2800 rpms. Also when I first start it I hear a rattle and little puff...

2003 Denali odometer/rpms? [ 2 Answers ]

I own a 2003 Denali and the speedometer/rpms gauges are only working some of the time or they freeze half way??

RPMs going crazy [ 1 Answers ]

I have a 1993 Acura Integra, B18 engine, the cars RPM gauge started to fluxuate and then the car would stall this happens when I am driving. I read the code. VSS was the code. The VSS is part of the speedometer gauge cluster, so I replaced the gauge cluster , reset the PCM and it still is acting up...

RPMs stay high when I stop. [ 7 Answers ]

Well, just got my first stick a while ago... been driving it, and I find that when I get it up to about 4500 RPM, and end up slowing to a stop, it usually only drops to about 3000, until I downshift into first (for stops) and let out the clutch... then, it drops to about 1500 or 2000, where it's...

Low rpms [ 1 Answers ]

I have a vanguard V21 engine in a lawn tractor and can't get the rpms up. The throttle is wide open but rpms are low. The choke is off. Its only 1 yr old with few hrs on it. Any ideas??


View more questions Search