Ask Experts Questions for FREE Help !
Ask
    amateur1477's Avatar
    amateur1477 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 7, 2015, 01:01 PM
    2000 hyundai tiburon manual transmission removal/replace.
    2000 hyundai tiburon manual transmission removal/replace. Did NOT change the clutch or remove release bearing, new transmission is all bolted together, how to reengage clutch fork to the release bearing?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Oct 7, 2015, 04:36 PM
    If you're lucky, and you have enough room, remove the slave cylinder and boot and try to attach the release fork through the opening in the transmission. The spring on the back of the release fork needs to snap over the pivot ball, after the fork engages the release bearing.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Were is oil pressure switch on 03 hyundai tiburon located [ 0 Answers ]

Were is the oil pressure switch located on 03 hyundai tiburon v6

2000 ford explorer transmission pan removal [ 3 Answers ]

Some of the transmission pan bolts are hidden behind the exhaust of my wife's 2000 Explorer. I want to change the filter and fluids but not sure I can access the trans pan bolts for the removal and installation of the unit (can't get at them with sockets). Any advise or hints on how to do this?...

I have a 2001 hyundai tiburon that the timing belt broke on It does not have a 4.0 e [ 0 Answers ]

I have a 2001 hyundai Tiburon that the timing belt broke on. It is a 6 cylinder not a 4. Is this still an interference engine

2003 Hyundai Tiburon random stalling [ 2 Answers ]

Hello, I own a 2003 Hyundai Tiburon with about 111133 miles on it. I just bought it from a private seller so I'm not completely sure about its maintenance history. It started acting strange two nights ago. I was sitting in a parking lot eating and I noticed the TAC falling and rising like it was...

2000 ford f250 diesel manual transmission issue [ 1 Answers ]

My clutch quit working, no signs of slipping or nothing. I was told it was probably the slave cylinder so I replaced it and nothing so I replaced the master cylinder and it still didn't work. So I took it to a local repair shop he pulled the tranny and found the arm that holds the trow out bearing...

View more questions Search