Check out some similar questions!

wcstarr · May 22, 2010, 06:21 PM

1995 Ford Explorer transmission 4.0/It will not change out of 1st gear unless you get it going and leave off the gas and give it a little time to shift, but I think it is going into 3rd gear. Otherwise it works fine, but the OD off light is flashing and the code says rpm too high for 2nd gear. If I put it manually in 2nd gear while moving it acts like you are in neutral. Can you give me an idea where to go from here?

TxGreaseMonkey · May 22, 2010, 07:59 PM

Clutch packs are likely shot. You may want to check out the outfit below, who are well-regarded:

http://www.jasperengines.com/transmissions.php

benljenkins · Jun 18, 2012, 09:58 AM

I have the same car and Nationwide Remanufactured Trasmissions www.nationwidereman.com helped me out for $999

TxGreaseMonkey · Jun 18, 2012, 11:58 AM

If you need a rebuild, check out Fred Jones Enterprises, LLC, which is a Ford Authorized Distributor of Motorcraft and Ford Remanufactured powertrain assemblies:

http://www.fred-jones.com/catalog/connector/