Ask Experts Questions for FREE Help !
Ask
    douglas422's Avatar
    douglas422 Posts: 13, Reputation: 1
    New Member
     
    #1

    Oct 31, 2012, 02:08 PM
    1993 honda accord blown headgasket
    I change the headgasket on my 1993 honda accord and it ran great for about 6 weeks then I ran it hot so it had water in the oil so I took the new head gasket off and it looks good what do you think should I put a new one on again
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Oct 31, 2012, 04:21 PM
    The head may have warped. I would machine the head, replace the valve guides and valve seals, install a new head gasket, torque everything to spec, and do it again. Be sure you fill your cooling system per your Owner's Manual, in order to eliminate air. You likely need to fill the radiator, until coolant comes out of the opened bleeder bolt; however, confirm this per your OM. I've seen head gaskets on Hondas blow because this was not done.
    douglas422's Avatar
    douglas422 Posts: 13, Reputation: 1
    New Member
     
    #3

    Oct 31, 2012, 05:02 PM
    Quote Originally Posted by TxGreaseMonkey View Post
    The head may have warped. I would machine the head, replace the valve guides and valve seals, install a new head gasket, torque everything to spec, and do it again. Be sure you fill your cooling system per your Owner's Manual, in order to eliminate air. You likely need to fill the radiator, until coolant comes out of the opened bleeder bolt; however, confirm this per your OM. I've seen head gaskets on Hondas blow because this was not done.
    OK that's what I needed to know thanks once again txgreasemonkey
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #4

    Oct 31, 2012, 05:08 PM
    Have a reputable machine shop, that specializes in heads, carefully inspect the head for any problems. Have them remove and clean the oil control orifice, which is sometimes hard to locate.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1993 honda accord dx [ 3 Answers ]

I got a 1993 honda accord dc, when I bought it from a friend, he said it had a bad starter. I replaced the starter. All interior instrument lights come on when you turn on the key, but nothing happens. You can push the car off and crank it. What do I need to check next?

2003 honda accord lx possibly a blown fuse not sure [ 2 Answers ]

I have a 2003 honda accord lx and recently my speakers went out actually the radio just stopped working but all the functions of the radio work fine and my speakers aren't blown. So after about 2 weeks it came back on but now my ac went out and I am wondering if this is an electrical problem maybe...

1993 Honda Accord EX [ 1 Answers ]

120,000 miles. 1. Runs rough at idle. Rough enough to shake the steering wheel. It has done this for at least 30,000 miles. 2. When the engine is warm it starts immediately. After it has set for awhile or overnight the engine will crank a long time, 30-45 seconds, before it starts. The cranking...

1993 Honda Accord LX [ 3 Answers ]

I need to know where the map sensor is located under dash or under hood ? Thank You Roy


View more questions Search