Ask Experts Questions for FREE Help !
Ask
    RachelCobia's Avatar
    RachelCobia Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 17, 2012, 09:12 AM
    Whirlpool LXR6432JQ0 Do I replace bad part or whole transmission?
    Should I replace just the intermittent transmission part, or the whole transmission? Also, is there harm in waiting on the repair and continuing to use the machine? Should I fix it right away? Below are the details of what the machine does.

    The "normal" cycle appears to be fine.
    Tried the "casual" or permanent press cycle. Here's what it does:
    Fills with water
    Agitates for several minutes
    Drains without spinning until maybe 4-5 inches of water are left. Pauses for almost a minute.
    Starts filling with water again, even though there was 4-5 inches in it already.
    Agitates again
    Drains for a few seconds until about 2/3 of the water is left, then starts spinning until the rest of the water is out.
    Stops.
    Spins again with an empty basin.
    **The second time it filled with water was BEFORE the rinse cycle. So the machine filled a total of 3 times.
    Filled with water for a third time.
    Agitated.
    Drained completely without spinning.
    Spun while rinsing, as normal.
    Finished the cycle.
    GENTLE CYCLE runs as I described before. YES it does drain and spin at the same time. Stops. Then spins again with an empty basin.
    Fills for a second time.
    Agitates.
    Drains completely without spinning.
    Then spins while rinsing and completes cycle.

Check out some similar questions!

Replace transmission range sensor [ 3 Answers ]

How do I replace the transmission range sensor in a ford windstar 2000

Whirlpool LXR6432JQ0 washer drains and spins at the same time? [ 0 Answers ]

My washing machine seemed to start spinning before it had completely drained. The basin had a lot of water in it, causing the machine to struggle to spin, obviously. I am concerned about it completely wearing out. We were told to check for an obstruction in the tube as it might not be draining...

How can I locate a transmission part for my car mazda 1995 with a b6 engine? [ 0 Answers ]

The name of the car is Mazda 323 familia at the year of 1995. It is motor car that recently develop problems at the transmission. It is not changing gear as it drives and oil leaks from the center of the engine and is dark and has a unusual odor (like the scent of something burning).

How do I tell whether my washer has a bad transmission or a bad electronic control pa [ 5 Answers ]

I have a GE Profile clothes washer that is about 8 years old. It used to go to a low speed spin before kicking into high speed. Now, it only goes directly into a high speed spin. When this began, it gave off a burning smell that alarmed my wife. It doesn't give off that odor when I run the "drain...

Replace Mazda transmission? [ 1 Answers ]

I have a 92 Mazda B2200 extended cab pickup with a manual transmission. It has a modified flatbed, but the exhaust pipe has been cut off at the back of the cab. The EGR light is also on. Recenltly I gave the vehicle a tune up for my first time (spark plugs, cap and rotor, filters and whatnot) The...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.