I have a Whirlpool washer. It works fine but sometimes the spin cycle does not seem to remove as much water. John

Kenmore series 80 heavy duty top loader will not cycle properly, it will stop after the washing cycle and we have to reset the timer knob (pull out then push in) to start it again. Could it be the timer (bad switch)? Once we do that it will go into it's next cyle OK.

My Kenmore washer will go through the wash cylce but when it reaches the spin cycle the water will drain out but will not spin out. I did replace the motor isolation cupling, but that did not take care of the problem. I'm thinking that the control magnet could be the culprit. Any thoughts?? LAJ

I have an old Kenmore 80 Washer and nothing works, but the spin-cycle. Many posts say that it's the Water inlet valve, but I don't want to spend $30-$40 to change it if it's not the right part. If it's the Water inlet valve, I figured if I filled the washer up with water the washing machine...

I have an Inglis Citation washer (15 years or so) that stops midcycle. The 15 minute cycle stops at the 6 minute mark but the timer keeps counting down to the rinse cycle. The rinse cycle does kick in and spins to completion. I had the timer rebuilt but that was a waste of money. Any help would...