Ask Experts Questions for FREE Help !
Ask
    toowet's Avatar
    toowet Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 31, 2006, 09:15 AM
    Standing Water in Dishwasher when finished
    GE Dishwahser model GSD5630D1 after dishwasher goes through all cycles about 2 inches of water in bottom of tub. Does this need a new sequence switch?
    sorethumb's Avatar
    sorethumb Posts: 1, Reputation: 1
    New Member
     
    #2

    Jan 29, 2007, 10:01 AM
    Quote Originally Posted by toowet
    GE Dishwahser model GSD5630D1 after dishwasher goes through all cycles about 2 inches of water in bottom of tub. Does this need a new sequence switch?
    Did you ever find the problem? I have the same one.
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #3

    Jan 29, 2007, 08:06 PM
    Where does the diswasher eject ist water? The garbage disposal? Can you hear water go into the GD, or the drain, through rinse cycles? Could be something as simple as a seed or obstruction in the drain hose.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water backup in dishwasher [ 1 Answers ]

When cleaning up after the holiday dinner, water backed up out of the disposal and into the dishwasher. It overflowed into the wood flooring and down to the level below. Is this a partial blockage in the disposal drain pipe that forced the drain water into the dishwasher? We have run the water and...

Kenmore Built-in 363 Dishwasher with Standing Water [ 1 Answers ]

Hi, We have a Kenmore 363 Built-in Dishwasher. The dishwasher is not draining all of the way - there is a puddle of standing water (at least a cup) under the cover inlet. We only use the dishwasher once a week or so, and the standing water is growing into something rather unpleasant. We...

Kenmore dishwasher won't heat water [ 3 Answers ]

I have a new Kenmore Elite dishwasher. I have checked the water during the Hi Temp wash cycle and the sani rinse cycle and it isn't any hotter than 133 degrees, the temp of the water from my water heater. The instructions say the water should be at a minimum of 129 from the tap and I always run the...

Ge dishwasher - water pump failure? [ 2 Answers ]

@ 2000 GE potscrubber It will fill with water, and drain, but it hums like an electrical motor is stuck, and no water pressure is making it to the rotator bar. Is there a pressure pump that may have failed? It appears to do everything, but spray water. Any ideas welcome. TIA Alex

No water from sink after installing dishwasher [ 1 Answers ]

I live in a house that was built in the early 1900s so the piping is really old and I didn't want to chance breaking anything so I went the cheap way out and I didn't sodder anything. I took the hose off from my hot water and added a T pipe that screws on to where the hose used to be. Left side...


View more questions Search