 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Keep going and you will replace all the parts, but you still may not fix it. A good $20.00 digital meter would have been cheaper and then you would only have to replace the bad part. You need to test it like parttime said. Your water level pressure switch is usually the cause of water level problems, and not just this switch but how it is hooked up. It has a plastic tube that connects to a fitting on the bottom of the tub and if it is stopped up, full of water, loose, or has a hole in it then the water level pressure switch will not work properly. Most of these switches have a large metal diaphragm case with the diaphragm on the inside. These is an adjustment screw on the back side away from where the plastic tube connects that can be adjusted to change when the switch is activated, but on yours there may not be an adjustment. I do not know if you can use a better type on your machine than the original. Here is one at $49.00 with the diaphragm: https://www.appliancezone.com/ShowProduct.aspx?ID=3055
Yours is listed here for $115.00: http://www.repairclinic.com/Shop-For...hine-Parts?n=4 The switch is tested with a meter by taking the end of the hose on the tub off and blowing in it while you test the terminals with an ohm meter to see if it is opening and closing the switch inside. The switch has one common and one terminal closed with no pressure and one terminal closed when pressure is on diaphragm. Here are some manuals to show you all you need to know: https://dl.dropboxusercontent.com/u/...c%20washer.pdf https://dl.dropboxusercontent.com/u/...%20Washers.zip https://dl.dropboxusercontent.com/u/...e%20Manual.pdf https://dl.dropboxusercontent.com/u/...Electronic.pdf https://dl.dropboxusercontent.com/u/...e%20Manual.pdf On page 7 of this manual you will find an excellent diagram of a fill switch and instructions on how to test it. Even if your switch looks different, like yours, it is still tested the same way. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Model X100 sells for $120 per unit whereas Model X200 offers advanced features and sells for $500 per unit. Management expects to sell 50,000 units of Model X100 and 5,000 units of Model X200 next year. The direct material cost per unit is $50 for Model X100 and $220 for Model X200. The company's...
There are some different wiring codes that are different how do I do it.
Washer stopped working. Will fill up but does nothing after that. I was told it is most likely the lid switch so I replaced the lid switch and that did not fix the problem. No matter what setting I use (other than fill), nothing happens -- no noise, no action, nothing. Tried opening and closing...
Hi I am selling my house and I would like to know the lifespan and long-term performance of this model of Beach oil burning furnace. And if possible, what year it was manufactured, I think it's in the 1970's or 80's. I need this information to provide to my realtor to find out if it needs to be...
Whirlpool top load LSQ9010PW2 fills, won't agitate, spin or drain. Makes humming noise and electrical burning smell then humming noise stops. A small click sound then the humming starts again.
View more questions Search
|
